Gyros Adaptor Chucks are made in the USA and constructed of durable Stainless Steel. They allow you to maximize the use of your small twist drills in any tool that can use 1/8" shank accessories. Easily switch between drilling and other uses for your motor tool without changing collets. Your drill can even be left pre-set in the chuck while your motor tool is being used with other accessories, thereby reducing setup time. Use with your Dremel® type tools.
Adaptor Chuck - Mini - 0 In. to .039 In. Capacity
The dynamically balanced, compact and streamlined design of our Mini Chuck allows it to spin true and vibration-free even at high speeds.
The shank and collet are precision machined from a single stainless steel billet, thus insuring optimum concentricity and balance.
The chuck has a collet capacity of 0"-.0390" (#61-#80). This makes the task of centering these tiny drill bits in a hand or electric drill simple and easy.
The integral collet design allows your drill bit to spin true, thus avoiding tool wear.
Accurate, precise and strong, these chucks have a popular 1/8" shank and can be run at 35,000 RPM. This is what makes the Gyros Mini Adaptor Chuck the preferred choice for use with micro drill bits.
MADE IN USA
Adaptor Chuck Set, 0 In. to .094 In. Capacity
Our Stainless Steel Adaptor Chuck is an all purpose chuck that comes with 2 collets and works with a full range of wire gauge drill sizes.
Makes the task of centering small drill bits in a hand or electric drill simple and easy.
The chuck has a cross drilled hole allowing you to easily tighten larger drills.
Together, the collets have a range of 0"-.094" (#42-#80).
Precise and strong, these chucks have a poular 1/8" shank and can be run at 15,000 RPM.