Quality Tools at Discount Prices
Over 40,000 Hand and Power Tools.

Welcome to our family of over 475,000 satisfied customers.

Ph: 800-347-5096 Hours: M-F 6:30a - 4:00p (Pacific)

Home

Klein Tool Index

Klein Conduit Bending Tools

Klein Benfield Conduit Benders

Klein Benfield Conduit Benders

Klein Benfield Benders Complete with Handle

Three bender / handle combinations cover a range of bending requirements for 1/2" to 1" EMT and 1/2" or 3/4" rigid conduit.
The benders and the handles are described on their individual pages.

56203

$56.50

Description

Assembled AEROHEAD™ Conduit Bender with #51247 Handle - 1/2" EMT

56204

$71.75

Description

#51202Bender Complete with #50473 Handle,
for 3/4" EMT or 1/2" rigid conduit.

56205

$94.75

Description

Assembled AEROHEAD™ Conduit Bender with #51249 Handle - 1" EMT

Bending Tips

For greater accuracy. Bear down with heavy foot pressure. Pin the conduit tight to the floor throughout the full arc.
Uniform long radii. Mark conduit in even increments and bend in even amounts at each mark.
Stub-Ups in narrow partitions. Bend a "Kick" in the conduit a few inches away from the partition... A conventional radius bend will then fit into a narrow space because it enters obliquely.
Bending both legs of an offset on floor. Make the second bend on a slightly raised platform (a 2" x 4" will usually do) or bend at edge of a loading dock, stairwell, etc. This allows first bend to hang in free air.
Avoiding crooked offsets. A chalk line on conduit permits alignment at identical registry points on the tool. Thus multiple bends are kept in the same plane.
Bending with tool in air. Apply hand pressure as close to the tool as possible... even if uncomfortable. Keep pressure close to the groove. Tucking conduit under armpit helps. To maintain balance allow the tool to rock forward as you make the bend.

Benders for 1/2" EMT have cast-in offset formula and multiplier, providing instant, on-the-spot information for making accurate offset-angle bends.

Depth x multiplier = Distance Between Bends

The "Multiplier Scale" opposite the degree scale makes it quick and easy to follow the formula.

EXAMPLE:

To make an offset 5" deep with 45" bends:
5" x 1.4 = 7"
1. Place marks 7" apart.
2. Make a 45° bend at each mark.

NOTE: On all Benfield Benders, a straight up handle (vertical to floor) indicates a 30° bend.

Benfield benders and hickeys are manufactured only by Klein Tools, Inc.

Benfield is a registered Trademark of Klein Tools, Inc.

	Back to Klein Conduit Bending Tools Index

	Back to Main Klein Tools Index

Home Page: Ideal, ExTech, Dewalt, etc.

SSL

Sales/Info 800-347-5096

4730 W. Spring Mountain Road, Las Vegas, Nevada 89102

FAX (702) 871-2815