Schonstedt Pipe & Cable Locator

Schonstedt Instruments MAC-51BX -Additional Information

The MAC-51BX (the most cost-effective, all-purpose locating system on the market) consists - a receiver and a transmitter that simultaneously transmits on two frequencies - 571 Hz (LF) and 82.5 KHz (HF). The receiver has a three position switch that lets you change modes, "on-the-fly", between LO, HI, and MAG, for cable and line tracing with break locating, pinpointing a ferrous metal target, or identifying and pinpointing an energized 50/60 Hz power line.

In the LO and HI modes, the receiver's audio signal provides a sharp null when its tip is directly over the target. In the MAG mode (no transmitter required) the audio signal peaks when the receiver's tip is over the target. You can trace the 571 Hz LF signal conductively applied to any continuous metal conductor up to 4000 feet.

The receiver's on-the-fly mode-changing feature lets you locate a complete break using the LO mode, and then continue on to trace beyond the break in the HI mode, or trace a metal pipe joined with non-conductive gaskets.

The MAC-51Bx by simultaneously transmitting 82.5 kHz (HF) and 571 Hz (LF) signals. This feature lets you select and compare received audio signals from both frequencies along with magnetic information without having to return to the transmitter.

Transmitter Inductive Mode (HF only)
Induction is achieved by placing the transmitter over the target cable/pipe or by using the optional Inductive Signal Clamp. It's the easiest and quickest way to applying a trace signal that is strong enough for tracing most lines. The trace signal generates an alternating magnetic field around the cable which induces a signal into the receiver's cable sensor. A sharp null in the audio signal between the two peaks occurs when the receiver's tip is directly over the cable.

Transmitter Conductive Mode
If an exposed section of a target gas or water pipe is accessible, conductive coupling is the most reliable method for applying the trace signal. This mode has to be used to apply both HF and LF frequencies so that you can use all three features on-the-fly. Providing a good electrical contact between the clip and the conductive portion of the target line by removing rust or paint before attaching the clip is very important.

Magnetic Locating Mode
Only the MAC-51Bx receiver is required when operating in the magnetic mode. Just set the Mode switch to MAG, the Gain control to mid-range, and you're ready to locate underground ferrous pipes, water meters, water valves, and property markers of or anything that has a magnetic field including the 50/60Hz electro-magnetic field generated by energized power lines.

Options

Mini-Transmitter
The MT-2 (Mole) is a miniature transmitter designed to be used in conjunction with the MAC-51Bx Receiver. It is just what you need to trace non-metallic pipes, pinpoint obstructions in pipes, locate concrete septic tanks, and monitor the course of utility tunneling under highways.

As the Mole, attached to the end of a sewer/ drain cleaning snake, is pushed through a non-metallic pipe, it emits a strong signal that you can detect and trace at depths up to 18 feet using the MAC-51Bx receiver set to the HI mode.

The MT-2 is very easy to attach to a plumber's snake with the use of electrical tape, due to it's one concave surface side.

The MT-2 provides years - trouble-free operation and uses one AAA penlight battery to provide up to 30 hours of operation. The battery cap also serves as the On/Off switch. You turn the power off by rotating the battery cap counterclockwise.

Inductive Signal Clamp
The Inductive Signal Clamp increases the versatility of the MAC-51Bx by providing a convenient method of selectively applying the trace signal to conductors covered with non-metallic insulation.

Accessory

Conductive Cable Assembly
The Conductive Cable Assembly is used for applying the tracing signal directly to an exposed section of a cable, line or metal conduit for maximum tracing distance.