Starrett Electronic Indicators

Electronic Indicators by Starrett

• Conform to the dimensions of AGD size Group 2
• Available with either a .375" (9.5mm) stem or an 8mm (.315") stem. Furnished with .375" (9.5mm) stem unless otherwise ordered
• 1" (25mm) range
• Readout available to .0005" and 0.01mm
• A large, right-sized, easy-to-read LCD digital readout, surrounded by a rotating black bezel
• Furnished with lug-on-center back
• Starrett-designed electronics microprocessor
• Output to Starrett SPC Plus^® system components on most models
• Utilizes standard indicator accessories and holding devices
• Battery powered and portable
• Rugged, sealed enclosure makes them F.F.F. (factory floor friendly)

• Instant inch/mm conversion
• Zero at any position
• Plus/minus control to indicate direction
• ON/OFF control with automatic off after one hour of nonuse. (Zero references will not be lost from memory)

• Bezel rotates the reading for convenient positioning
• Instant inch/mm conversion
• Zero at any position
• Ability to retain and return reading to the original zero reference (zero absolute [ABS])
• Plus/minus control to indicate direction
• Min/Max/TIR – Min/max mode is used to retain the lowest and highest readings in a group, and TIR gives the difference between them
• Limits mode to enter low and high limits for tolerance control. This is easily done by the shift control to enter the proper function
• Preset is used to install any reading at any point in the display and is also done with the shift control
• ON/OFF control with automatic off after one hour of nonuse. (Zero references will not be lost from memory)
• Output jack allows data transmission to the following peripherals for SPC analysis, data collection and hard copy documentation
• • Starrett No. 772 Series Advanced Data Collection Systems
  • Starrett No. 761 Series Data Multiplexers
  • Works well with Starrett DataSure^® Wireless Data Collection System
  • Other devices that support RS232C