Electronic Height Gage (without output) by Starrett
No. 3751 (0-6"/150mm)
This height gage is light, portable and easy to use for vertical measurements within its range.
Readability Features
- Easy-to-read LCD .32" high characters
Accuracy and Long Life Design Features
- Hardened, stainless steel bar for long life
- Depth attachment No. PT08680A available for measuring depth of holes, slots, and recesses
- Fine adjustment thumb roll for precision measurements
- Rounded nose scriber cuts clean, sharp lines with smoothness and less pressure
- Lock to hold the slide in position
- Hardened, ground, and lapped base with finger grooves provides ease of movement
- Easy access to single long-life battery, 3-volt CR2032
- Vertical bar is back from the edge of the nose for better stability
- Scriber can reference zero from the bottom of the base to get the full 6" (150mm) usable range
- Linear Accuracy: ±.001" (± 0.03mm)
- Resolution: .0005" (0.01mm)
Action Features with Three Control Buttons
- Inch-millimeter conversion
- Zero at any position
- Manual ON/OFF plus a built in automatic OFF after 5 minutes of nonuse
|
 |
Starrett Tool Index 
