V-Block and Clamp for Round or Square Work by Starrett
No. 568 2" (50mm) Round, 1-7/16" (36mm) Square Capacity
|
| |
|
|
 |
|
| Pair of identical No. 568 V-Blocks, showing clamps in two different positions, for round or square work. V-Block at left has clamp in low position with screw at 45° for holding square work. V-Block at right has clamp
in high position and screw at 90° for holding round work.
|
|
These rugged and versatile blocks have the following features:
- Hardened steel, precision ground parallel and square
- V-grooves are ground central and parallel to the sides and base – perfect alignment in matched pairs
- Clamps have screw holes at 45° and 90° to hold either square or round work
- Stepped groove construction permits high or low clamp mounting for small or large work
- Clamps do not project over the width of the block, permitting it to be used on the base, ends or sides
- 3/8-16 tapped holes permit mounting blocks on faceplates or angle irons
- Each block is 2-1/2" long x 3" wide x 2" high (63 x 75 x 50mm)
|
Starrett Tool Index 
