Starrett Combination Steel Rule Depth
and Angle Gages
No. 236 Series
This Starrett 6" (150mm) Depth Gage has an added feature permitting its use as a protractor for measuring angles.
- The head is graduated both left and right to 30, 45, and 60 degrees. The rule can be set to any of these angles by swinging the rule until the line on the turret coincides with
desired angle.
- Head is made of hardened steel, accurately ground and nicely polished - 2-5/8" (66mm) long and 1/8" (3mm) wide
- One side of the base is cut out to permit easier and more accurate readings
- The center of the head is recesssed so that the tool will lay flat to permit more accurate measurements
- A tempered rule that has been accurately machined divided, is smoothly fitted to the head and can be locked in position by a knurled nut
No. 236H Series
These Starrett Combination Depth Gages can be used for calipering, as a depth gage by reversing the rule, as a protractor, and as a hook rule when removed from the tool.
- Features are the same as the No. 236 except that a hook rule and an extra 6" (150mm) long rod are furnished with this gage. The rod has a 5/64" (2 mm) diameter so it can
measure the depth of small holes, slots and recesses that the rule will not enter.
|
Left: No 236, Right: No. 236HB (with hook rule and rod). |
View
Cart
|
FAX Order | Tell
a Friend | Contact Us 
